The Landscape Genius
Flowerbeds & Hedging in La Porte, TX
Fresh flowerbeds, clean edges, and shaped hedges suited to Gulf Coast heat and clay soil.
A flowerbed job starts with what is already there. Old mulch and dead plant material get pulled, the bed edge gets cut clean with a spade or edger, and the soil underneath gets checked. Around La Porte and Deer Park that soil is usually heavy clay, which holds water in the wet months and cracks hard in August, so amending it before anything goes in the ground matters more here than in a lot of places. Once the bed is shaped and the soil is workable, plants go in, then mulch, then a final trim on any hedges tying the bed together.
Bad edging is the most common failure homeowners do not notice until it is a problem. If the edge is shallow or uneven, St. Augustine and Bermuda grass will run right through it within a season and the bed line disappears. Hedges cut on a whim rather than on a plan also tend to get leggy at the base and bare on top, which no amount of trimming fixes without letting them grow back out first.
Ask what is being used to amend clay soil, and ask whether plant choices are suited to full Texas sun or partial shade before anything goes in the ground.
How it runs
- Clear the bed Old mulch, weeds, and dead plant material are pulled out down to bare soil.
- Cut the edge A clean edge is cut around the bed to hold its shape and keep grass from creeping in.
- Prep the soil Clay soil is amended so water drains instead of sitting around roots.
- Plant and mulch New plants go in, then a mulch layer to hold moisture and cut down on weeds.
- Shape the hedges Hedges are trimmed to a clean line that fits the rest of the bed.